Nokia Bluetooth Headset BH 118 User Manual

Nokia Bluetooth Headset BH-118 User Guide  
Issue 1.0  
 
3
Introduction  
About your headset  
With the Nokia Bluetooth Headset BH-118, you can make and receive calls while on  
the move.  
Read this user guide carefully before using the product. Also, read the user guide for  
the device that you connect to the product.  
Warning:  
This product may contain small parts. Keep them out of the reach of small children.  
The surface of this product is nickel-free.  
About Bluetooth connectivity  
You can use Bluetooth to make a wireless connection to other compatible devices,  
such as mobile phones.  
Devices do not need to be in direct line-of-sight, but they must be within 10 metres  
(33 feet) of each other. The connection may be affected by obstructions such as walls  
or other electronic devices.  
This device is compliant with Bluetooth Specification 2.1 +EDR supporting the  
following profiles: Headset Profile (HSP) 1.1, Handsfree Profile (HFP) 1.5. Check with  
the manufacturers of other devices to determine their compatibility with this device.  
 
     
4
Get started  
Keys and parts  
1
2
3
4
5
6
7
Earpiece  
Microphone  
Earpiece holder  
Multifunction key  
Clip  
Charger connector  
Indicator light  
Parts of the product are magnetic. Metallic materials may be attracted to the product.  
Do not place credit cards or other magnetic storage media near the product, because  
info stored on them may be erased.  
Charge the battery  
Before using the headset, you must charge the battery.  
Warning:  
Use only chargers approved by Nokia for use with this particular model. The use of  
any other types may invalidate any approval or warranty, and may be dangerous. Use  
of unapproved chargers may present a risk of fire, explosion, or other hazard.  
When you unplug a charger, hold and pull the plug, not the cord.  
1
Plug the charger into a wall outlet.  
 
     
5
2
3
Connect the charger cable to the charger connector on the headset. The red  
indicator light turns green when the battery is fully charged. Charging the battery  
fully may take up to 2 hours.  
Disconnect the charger from the headset, then unplug from the wall outlet.  
The fully charged battery has power for up to 6 hours of talk time or up to 120 hours  
of standby time.  
When the battery charge is low, you hear a voice prompt, the headset beeps every 5  
minutes, and the red indicator light flashes. When the battery is charging, the red  
indicator light is on.  
Check the battery charge  
Make sure the headset is switched on, then press . A green light indicates a  
sufficient charge level. If the light is yellow, you may need to recharge the battery  
soon. If the light is red, recharge the battery.  
Switch the headset on or off  
Switch on  
Press and hold  
flashes once.  
for 2 seconds. The headset beeps, and a green indicator light  
The headset connects to the last connected phone or other device. If you have never  
paired the headset, or you have cleared the pairings, the headset switches to pairing  
mode.  
Switch off  
Press and hold  
once.  
for 5 seconds. The headset beeps, and a red indicator light flashes  
If not connected to a phone within 30 minutes, the headset switches off.  
Pair and connect the headset to your phone  
Before using the headset, you must pair and connect it to a compatible phone.  
1
2
3
Switch the headset off.  
Switch your phone on.  
If you have never paired the headset, or you have cleared the pairings, switch the  
headset on.  
If you have previously paired your headset with a device, press and hold  
for 5  
seconds.  
 
   
6
The headset switches to pairing mode, and a green indicator light starts to flash  
quickly.  
4
Within 3 minutes, switch Bluetooth on in your phone, then set it to search for  
Bluetooth devices. For details, see the user guide of your phone.  
5
6
Select the headset from the list of found devices.  
If needed, type in the passcode 0000.  
You can pair your headset with 8 compatible phones, but you can only connect it to  
a maximum of 2 phones at the same time.  
With some devices, you may need to make the connection separately after pairing.  
When the headset is paired to your phone and is ready for use, the green indicator  
light flashes about every 5 seconds.  
Switch the voice guidance off  
If you'd prefer to use your headset without the voice prompts, you can switch them  
off.  
1
2
To switch the headset off, press and hold  
for 5 seconds.  
Press and hold  
for 5 seconds. The headset switches to pairing mode, and a  
green indicator starts to flash quickly.  
To switch the headset on, press and hold  
3
for 2 seconds.  
Switch voice guidance back on  
Follow the same steps used to switch voice guidance off.  
Wear the headset  
Use the clip to attach the headset to your clothing.  
 
   
7
To have the earpiece within easy reach when not using the headset, keep the earpiece  
in the holder.  
Make calls  
Make and receive calls  
To make and receive calls using your headset, you need to connect it to your phone.  
Make a call  
Make a call in the normal way.  
Answer or end a call  
Press  
.
Reject a call  
Press  
twice.  
Switch a call from your headset to a compatible phone  
Press and hold  
Switch a call from a compatible phone to your headset  
Press and hold for 2 seconds, or switch the headset on.  
for 2 seconds, or switch the headset off.  
When you're not in a call, you can redial the last called number or use voice dialling,  
if your phone supports these features with the headset.  
 
   
8
Redial the last called number  
Press  
twice.  
Use voice dialling  
Press and hold for 2 seconds, then follow the instructions in the user guide of your  
phone.  
Change the volume  
Set the desired volume level on your connected phone. The selected volume level is  
saved as the minimum volume level for the phone that is currently connected to the  
headset.  
Pair and connect the headset to two phones  
When you use the headset for the first time, it automatically connects to your phone.  
You can also connect your headset to another phone, and manage calls from, for  
example, both your personal and your work phone at the same time.  
1
2
To switch the headset off, press and hold  
To activate pairing mode, press and hold  
with the second phone.  
for 5 seconds.  
for 5 seconds, and pair the headset  
3
Make sure Bluetooth is activated on both phones, and switch the headset off and  
back on. The headset connects to both phones.  
Handle calls from two phones  
If your headset is connected to two phones, you can handle calls from both at the  
same time.  
End an ongoing call, and answer a call on another phone  
Press  
Put an ongoing call on hold, and answer a call on another phone  
Press and hold for 2 seconds.  
Switch between active and held calls  
Press and hold for 2 seconds.  
End an ongoing call, and activate a held call  
Press  
.
.
If you redial or use voice dialling, the call is made on the phone you last had an active  
call on with the headset.  
 
     
9
Settings  
Clear device pairings  
1
2
To switch the headset off, press and hold  
Press and hold for 9 seconds. The headset beeps twice, and the red and green  
indicator lights alternate.  
for 5 seconds.  
After the pairings are cleared, the headset enters pairing mode.  
Product and safety information  
Battery and charger information  
This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as  
you may damage the device.  
This device is intended for use when supplied with power from the following chargers: AC–11, AC-3, AC-8, AC-15, DC-4. The  
exact charger model number may vary depending on the type of plug. The plug variant is identified by one of the following:  
E, X, AR, U, A, C, K, B, or N.  
The battery can be charged and discharged hundreds of times, but it will eventually wear out.  
Talk and standby times are estimates only. Actual times are affected by, for example, device settings, features being used,  
battery condition, and temperature.  
If the battery has not been used for a long time, to begin charging, you may need to connect the charger, then disconnect  
and reconnect it.  
If the battery is completely discharged, it may take several minutes before the charging indicator is displayed.  
When your charger is not in use, unplug it from the electrical plug and the device. Do not leave a fully charged battery  
connected to a charger, as overcharging may shorten the battery’s lifetime. If left unused, a fully charged battery will lose  
its charge over time.  
Always keep the battery between 15°C and 25°C (59°F and 77°F). Extreme temperatures reduce the capacity and lifetime  
of the battery. A device with a hot or cold battery may not work temporarily.  
Do not dispose of batteries in a fire as they may explode. Dispose of batteries according to local regulations. Recycle when  
possible. Do not dispose as household waste.  
Use the charger for its intended purpose only. Improper use or use of unapproved chargers may present a risk of fire,  
explosion, or other hazard, and may invalidate any approval or warranty. If you believe the charger is damaged, take it to a  
service centre for inspection before continuing to use it. Never use a damaged charger. Only use the charger indoors.  
Take care of your device  
Handle your device, charger and accessories with care. The following suggestions help you protect your warranty coverage.  
Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that corrode  
electronic circuits. If your device gets wet, allow the device to dry.  
Do not use or store the device in dusty or dirty areas. Moving parts and electronic components can be damaged.  
Do not store the device in cold temperatures. When the device warms to its normal temperature, moisture can form  
inside the device and damage electronic circuits.  
 
     
10  
Do not attempt to open the device.  
Unauthorised modifications may damage the device and violate regulations governing radio devices.  
Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and mechanics.  
Only use a soft, clean, dry cloth to clean the surface of the device.  
Recycle  
Always return your used electronic products, batteries, and packaging materials to dedicated collection points. This way  
you help prevent uncontrolled waste disposal and promote the recycling of materials. Check how to recycle your Nokia  
Crossed-out wheeled-bin symbol  
The crossed-out wheeled-bin symbol on your product, battery, literature, or packaging reminds you that all electrical and  
electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This  
requirement applies in the European Union. Do not dispose of these products as unsorted municipal waste. For more  
environmental information, see the product Eco profile at www.nokia.com/ecoprofile.  
Copyright and other notices  
DECLARATION OF CONFORMITY  
Hereby, NOKIA CORPORATION declares that this BH-118 product is in compliance with the essential requirements and other  
relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/  
© 2012 Nokia. All rights reserved.  
Nokia, Nokia Connecting People, and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia  
Corporation.  
Reproduction, transfer, distribution, or storage of part or all of the contents in this document in any form without the prior  
written permission of Nokia is prohibited. Nokia operates a policy of continuous development. Nokia reserves the right to  
make changes and improvements to any of the products described in this document without prior notice.  
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Nokia is under license.  
To the maximum extent permitted by applicable law, under no circumstances shall Nokia or any of its licensors be responsible  
for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.  
The contents of this document are provided "as is". Except as required by applicable law, no warranties of any kind, either  
express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular  
purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise  
this document or withdraw it at any time without prior notice.  
The availability of products may vary by region. For more information, contact your Nokia dealer. This device may contain  
commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion  
contrary to law is prohibited.  
 
11  
/Issue 1.0 EN  
 

Miller Electric Welder WC 24 User Manual
MTD Lawn Mower 998 Sereis User Manual
Murphy Network Card 75160 Series User Manual
Netopia Network Router 3386 ENT User Manual
NeumannBerlin Microphone TLM 170 R User Manual
New Leader Battery Industry Automobile L2020G4 User Manual
Niles Audio Speaker CORAL RS8SI User Manual
Numark Industries Musical Instrument DM2002X User Manual
Palsonic Microwave Oven PMO 585 User Manual
Panasonic Digital Camera AJ D910WBP User Manual